Fort Wayne Auto Repair

Race car drivers have demonstrated the advantages of disc brakes, so most modern vehicles use them.  Sometimes just the front wheels have disc brakes, but many vehicles now have them all the way around. 

A major component of the disc brake is called a caliper.  It works by squeezing brake pads against the disc or rotor, kind of like a bicycle hand brake.  The brake pads themselves are what contact the rotor, causing friction to build and the wheel to slow down, but it's the calipers that apply the pressure to the pads.

Caliper design has evolved over the years, and there are two common types.  One is called a floating caliper.  It has one or two pistons on one side of the disc. When you push down the brake pedal, the piston or pistons in your caliper put pressure on that one side.  A mechanism connected on the other side of the disc applies pressure as well, squeezing your disc so the vehicle stops.  Floating calipers are less expensive since they have fewer parts.

The other type is called a fixed caliper.  They use pistons on both sides of the disc, sometimes several.  They are often used in more high-performance or heavy-duty vehicles.

Calipers can have rubber seals to keep out dirt, debris and moisture, but when that rubber wears out, sometimes the calipers can get contaminated.  They can stick or start leaking; they can even rust.  Then your caliper can get stuck applying that "squeeze" when you are not pressing on the brake pedal.  Or they can get stuck in the other position, not applying stopping power when you press the pedal.

When this happens, it's not unusual to feel your vehicle pull to one side when you brake.  You might notice a burning smell from the constant friction if the caliper is stuck on, plus you may feel the heat from the wheel after you park and get out of your vehicle.  Sometimes you'll hear a high-pitched sound or clunk if your calipers are binding up. 

That's your cue to have them checked out at your vehicle service center.  If your calipers aren't working correctly, it can be a safety hazard.  Sticking calipers can affect your ability to steer and stop; this is the kind of "brake time" you need so you can get them back on track and working properly.

Ed's Car Care Center
7811 North Clinton Street
Fort Wayne, IN 46825
2604835721
http://www.edscarcarecenter.com

If there’s one thing you should pay attention to with your vehicle, it’s the temperature gauge. It’s the one that may say C---H (that means “cold---hot”).  Or maybe yours has a picture of a thermometer on it and a blue and red zone.  If you see the needle heading farther to the “H” or red area, that means your vehicle’s engine is running hotter than it normally does.

One of the most common causes of an engine running hot is a leak in your cooling system.  Maybe you’ve seen puddles of coolant under your vehicle, or you’ve smelled the coolant, either inside or outside your vehicle (it has a sort of “sweet” or fruity smell). That’s your engine giving you a warning signal that it’s time to head over to your repair facility to find out what’s going on.

Your vehicle’s coolant can leak for several reasons.  You may have hoses that are deteriorating (heat and age take their toll). It’s possible the pump that circulates coolant has developed a problem (seals and bearings can fail from heat and wear).  You may have something as simple as a bad radiator cap.  Or your radiator or heater core may have holes in it. 

If your coolant is leaking out, this can cause serious damage to your engine if you just let it go.  Your engine could get so hot that some of the metal parts start to warp.  Sometimes, your coolant can start mixing in with your engine oil.  That can result in a very expensive repair if it gets to that stage, so have it checked out before that happens.

A technician will visually inspect your coolant system, including the reservoir tank, check hoses and fittings, test the water pump, and also may pressure test the radiator.  When the problem or problems are found, they will replace the necessary parts and get you back on the road. 

When it comes to a coolant leak, finding the cause can be tricky.  But it’s important to catch a cooling system issue in time—before your engine sustains more serious damage.  Now, that’s pretty cool.

Ed's Car Care Center
7811 North Clinton Street
Fort Wayne, IN 46825
2604835721
http://www.edscarcarecenter.com

If someone told you there was a fairly inexpensive way to improve your vehicle's handling, fuel economy and extend the life of your tires, you'd probably ask, "What do I have to do?" The answer is to rotate your tires.  But you have to do it regularly.

A lot of drivers think skipping tire rotation is a way to save money.  But when you don't rotate your tires, they will almost certainly wear unevenly.  That's because when your tires touch the surface of the road, the friction and traction causes miniscule parts of the rubber to come off.  And that process isn't exactly the same on each corner of your vehicle.  Some vehicles have the drive wheels in the front, some in the rear and some on all wheels.

Rotating your tires at regular intervals minimizes the differences in the way the tires wear.  The amount and pattern will be spread out equally if your tires spend time at all different positions.  The more even the wear, the more consistent traction, handling and braking will be.  All four tires will last longer this way, and when it is time to replace your tires, they'll all be worn out the same so you can replace all four with the same model tire.

Some people who choose not to rotate their tires find that one or two will wear much faster than the others, and often they'll replace just the worn ones.  While you can find similar tires, they won't all be the same and will certainly not have the same amount of wear. 

There are different tire rotation patterns depending on several factors: front-wheel drive, rear-wheel drive, all-wheel drive, directional tires/wheels, different sized wheels/tires on front and rear axles.  Also keep in mind that when your tires are new, some tire manufacturers require you to rotate them or else they won't honor the warranty. 

Your manufacturer recommends intervals for tire rotation, so it's best to follow their suggestion.  Your vehicle service facility can advise you when you need to get your tires rotated.  And many facilities include free tire rotation for as long as they're on your vehicle if you buy your tires at their shop.

Ed's Car Care Center
7811 North Clinton Street
Fort Wayne, IN 46825
2604835721
http://www.edscarcarecenter.com

At one time or another, most drivers honk their horn at someone who might be texting at a stoplight or not paying attention when they're driving.  But what happens when you tap on your horn and all of a sudden it won't quit? Everyone's looking at you like you're an angry jerk and all you want to do is turn it off!

It helps to know the basics of what's happening when you honk your horn.  There's a switch in the steering wheel, of course, and when you press on it, it sends power to a relay which then energizes the horn.  Bingo.  Sound.  When the horn sticks on, one of these parts or the wiring has developed a problem. 

With the ear-splitting noise inside your cabin, it may be hard to keep your cool, but do your best to stay calm.  Try pushing the horn several times; it may un-stick the switch if you're lucky.  If not, there are a couple of things you can try.

First, if you can, pull your vehicle off the road and into a spot where you're not disrupting traffic.  If you feel comfortable rummaging around in your vehicle's fuse box, you might be able to pull the fuse that manages the circuit for your horn system.  A hint: the fuse boxes sometimes have a label inside showing which fuse goes to which part of the vehicle. Find the fuse that goes to the horn and pull it out (sometimes there's a fuse-pulling tool inside the fuse box).

But many people don't feel like tackling that.  Yes, you can drive over to a service facility with the horn blaring (not the best idea).  Or call your service facility and see if they might be able to send someone over to where you are so they can shut off the horn.

At the shop, a technician can check wiring, switches, relays and other components to find out what's wrong.  This is something that should be left to a professional for a couple of reasons.  First, repairs around the steering wheel can involve airbags.  Second, some horn components may be part of a vehicle's alarm system. 

The bad news is that your horn may not give you any warning before it starts blaring uncontrollably.  But the good news is that a horn doesn't malfunction all that often, and now you have a plan if it does.    

Ed's Car Care Center
7811 North Clinton Street
Fort Wayne, IN 46825
2604835721
http://www.edscarcarecenter.com